Agilent Technologies Turbo-V 81-AG Notice De Mode D'emploi page 298

17 Technical Information
Error Messages
1
Indicates a fault in the circuit of the controller used to power the
pump.
If the pump is stopped by an emergency stop signal provided via a remote
NOTE
contact, the display will be as shown in the following figure.
Controller power supply circuitry is faulty, or the Controller received
a spike.
298/306
Press the STOP RESET pushbutton twice to start the pump.
P O W
S
O V
1
Remove the controller power cable and check the emergency
condition.
2
Then reconnect the power cable and press the START
pushbutton to start the pump.
O V E
1
Press the START push-button twice to start the pump. Should
the message still be present, call the Agilent service.
S H O R
1
Check connections and shortages between pump and
controller, then press the STOP RESET pushbutton twice to
start the pump.
Turbo-V 81-AG Rack Controller User Manual / 87-900-986-01
E R F
Y S T E M
E R R I D
R V O L T
T C I R
A I L
E
A G E
C U I T
(I)