Agilent Technologies Turbo-V 81-AG Notice De Mode D'emploi page 272

17 Technical Information
Use




272/306
ANALOG OUT TYPE: permits selection of the type of signal to be
sent to the programmable analogue output. One of the following
signals can be selected:
FREQUENCY: the drive frequency of the pump is shown

POWER: the power supplied to the pump is shown

 TEMPERATURE: the temperature of the pump is shown
PRESSURE: the pressure read by the gauge is shown.

START OUT MODE: Selects the operating mode of the START
output. Possible options:
RUNNING: the output is active when the pump is driven

STARTING: the output is active only during acceleration

ramp-up.
SPEED OUT MODE (KRPM/Hz): permits selection of the unit of
measurement of the speed of rotation shown on the display of
the controller. This setting acts only on the measurement shown
on the display. Possible options:
KRPM

Hz

LCD CONTRAST
Turbo-V 81-AG Rack Controller User Manual / 87-900-986-01 (I)