Gardena EasyCut 23/18V P4A Mode D'emploi page 11

To charge the battery [ Fig. O1 / O2 / O3 ]:
CAUTION!
v Note the mains voltage! The voltage of the power source must
match the voltage specified on the rating plate of the charger.
For the GARDENA Battery Trimmer Art. 14700-55 / 14701-55 there
is no battery and no charger in the scope of delivery.
Thanks to the intelligent charging process, the charge condition of the
battery is automatically detected and then charged up with the optimal
charge current depending on battery temperature and voltage.
In this way, the battery is treated with care and remains permanently fully
charged when it is stored in the charger.
1. Push the locking button (A)
(D)
holder .
2. Connect the battery charger
3. Slide the battery charger (C)
When the battery charge indicator
the battery is being charged.
When the battery charge indicator
permanently green the battery is completely charged
(Charging time, see 7. TECHNICAL DATA).
4. Examine the charge status regularly while you charge.
(B)
5. When the battery is completely charged, you can disconnect the
battery (B) from the charger
Meaning of the Indication Elements:
Indication on the charger [ Fig. O3 ]:
Flashing of the Battery The charging procedure is indicated by flashing of the battery charge
(Lc) (Lc)
Charge Indicator indicator
Note: The charging procedure is only possible when the battery
temperature is within the allowable charging temperature range,
see 7. TECHNICAL DATA.
Continuous Lighting Continuous lighting of the battery charge indicator
of the Battery the battery is fully charged or that the temperature of the battery is
(Lc)
Charge Indicator not within the allowable charging temperature range and can therefore
not be charged.
When the battery is not inserted, continuous lighting of the battery
charge indicator
socket outlet and that the battery charger is ready for operation.
Battery charge status indication
After starting the product, the battery charge status indication
is displayed for 5 seconds.
Battery charge status
67 – 100 % charged
34 – 66 % charged
11 – 33 % charged
0 – 10 % charged
If the LED (L1) flashes green, the battery must be charged.
If the error LED (Wp) is illuminated or flashing, see 6. TROUBLESHOOTING.
To set the working position:
Working position 1 [ Fig. O5 ]:
For standard trimming.
Working position 2 [ Fig. O6 /O7 ]:
Trimming beneath obstacles
The tube can be lowered from standard position 1 to two lowered
positions 2 or 3 for trimming beneath obstacles.
1. Put the trimmer on the floor.
2. Hold the trimmer by the tube
push the unlock button (10)
(10)
3. Push the unlock button
position.
4. Release the unlock button
Working position 3 (only for Art. 14701) [ Fig. O8 /O9 ]:
Cutting at lawn edges.
CAUTION! The trimmer may only be used when the trimmer head
is locked at 0° or 90°.
To rotate the trimmer head
position 1.
14700-20.960.01.indd 11
and remove the battery (B) from the battery
(C) into a mains socket.
.onto the battery (B) .
(Lc) at the charger flashes green
(Lc) at the charger illuminates
(C) .
.
(Lc)
indicates that
(Lc)
indicates that the mains plug is inserted in the
(P) on the product [ Fig. O4 / O14 ]:
Battery charge status indication
(L1) , (L2) and (L3) illuminate green
(L1) (L2)
and illuminate green
(L1) illuminates green
(L1) flashes green
(7)
with both hands so that you can
with one finger.
(7)
and lower the tube to the required
(10) (7)
and let the tube engage again.
(1) to 90°, the tube must be in standard
1. Hold the trimmer by the tube
push the unlock button
2. Push the unlock button
0° to 90° until it engages.
3. Release the unlock button
To adjust the tube length [ Fig. O10 ]:
DANGER!
The product must not be used when the tube is completely
inserted (transport position).
1. Loosen the clamping sleeve
(7)
2. Pull out the tube to the required length.
3. Tighten the clamping sleeve again
To adjust the position of the additional handle [ Fig. O11 ]:
The position of the additional handle can be adjusted to your body height.
(12)
1. Pull the lever .
2. Tilt the additional handle
3. Release the lever (12) again.
If the trimmer is correctly set to the body height, the posture is upright and
the trimmer head in working position 1 is tilted forwards slightly.
v Hold the trimmer by the main handle
such a manner that the trimmer head is tilted forwards slightly.
To adjust the plant guard:
– Work position [ Fig. O12 ]
– Park position [ Fig. O13 ]
v Pull off the plant guard
it engages.
To start the trimmer [ Fig. O1 /O14 ]:
DANGER! Risk of injury!
Risk of injury if the product does not stop when you
release the start lever.
v Do not bypass the safety devices or switches. For example do
not attach the start lever to the handle.
The product is provided with a two-switch safety device (start
(P) lever with starting lockout) to prevent the product from being
turned on by accident.
To start:
1. Put the battery (B) into the battery holder
2. Hold the additional handle
3. Hold the main handle (14)
(15)
lockout forward and pull the start lever
The trimmer starts and the battery charge status indication
displayed for 5 seconds.
4. Release the starting lockout
CAUTION! Avoid contact of the plastic blade and the blade carrier with
hard objects (walls, stones fences etc.) to prevent the plastic blade and
the blade carrier from wearing or breaking.
To stop:
1. Release the start lever (16)
The trimmer stops.
2. Push the locking button
holder (D) .
4. MAINTENANCE
DANGER! Risk of injury!
Cut injury when the product starts accidentally.
v Wait for the plastic blade to stop and remove the battery
before you maintain the product.
To clean the trimmer [ Fig. M1 ]:
DANGER! Risk of injury!
Risk of injury and risk of damage to the product.
(7)
with both hands so that you can
(11) with one finger.
(11) (1)
and rotate the trimmer head from
(11) and let the tube (7) engage again.
(6) .
(6) .
(13)
to the desired position.
(14)
and additional handle
(5) and put it on into the required position until
(D) until it audibly engages.
(13)
with one hand.
with the other hand, slide the starting
(16)
.
(15) again.
.
(A) (B)
and remove the battery from the battery
(13)
in
(P) is
11
19.08.20 10:08