Cleaning And Maintenance; Safety Advice; Cleaning - Bartscher 4 ICE Mode D'emploi

WARNING! Risk of injury!
To avoid injury, you should never try to insert ice cubes under the blades using
your hands or by other means.
•
If a larger piece of ice is stuck in the unit and the blades do not reach it, you should
turn the ON/OFF switch to the "O" position and remove the cord from the outlet.
•
Pour hot water through the funnel for filling until the embedded piece of ice melts and
falls out.
•
Re-insert the plug of the unit in the outlet, turn the ON/OFF switch to the "I" position
and continue the process of crushing, filling the funnel again with ice cubes.
•
When the crushing process is finished, you can remove the container with crushed
ice. In such a case, the contact switch is automatically deactivated, and the ice
crusher stops the ice crushing process.
•
Turn the ON/OFF switch to the "O" position and remove the cord from the outlet
(pull out the plug!), if it is not being used further.

6. Cleaning and maintenance

6.1 Safety advice

o Before beginning with repair or cleaning works make sure the device has been
disconnected from power socket (pull the power plug!!!) and has cooled down.
o Do not use any acid agents and make sure no water ingresses the device.
o To protect yourself from electric shock, never immerse the device, its cables and the
plug in water or other liquids.
CAUTION!
The device is not suited for direct washing via water jets. Therefore, you must not
use any kind of pressure water jet for cleaning the device!

6.2 Cleaning

o The unit should be one cleaned after every use, as well as after longer pauses
between use.
o Remove the unit from the power source (pull out the plug from the outlet!).
o Remove the ice container and empty it.
o Remove the funnel for filling from the unit.
o Wash the ice container and funnel for filling using mild cleaners. Rinse thoroughly
these parts in clean water.
- 22 -