Cleaning And Maintenance; Safety Advice - Bartscher A200052 Mode D'emploi

•
After putting the jars in the cointainer pour so much water so that the jars are
immersed to approx. ¾ of their height.
•
Connect the device to a suitable power socket.
•
Set the preserving temperature. Read the temperature and the preserving time in a
cookery book or in indications of a special recipe.
NOTE!
Pay attention to the fact that the heating time does not depend on the preserving
time. The preserving time starts when the green control light of heating goes off
for the first time.
•
After preserving, disconnect the device from the power socket (take out the plug!).
•
Take the jars out of the preserving pot. While doing that, use tongs for taking out
jars or a cloth so as to avoid burning your hand.
•
Leave the water in the device to cool and then empty the pot.
CAUTION!
The device is equipped with protection against
overheating.
If the device happens to be empty when turned
on, the overheating protection will be activated.
Remove the plug from its socket and leave the
device to cool for approx. 30 minutes.
Next, press the RESET button located at the
bottom of the device.
The device is ready for use.

6. Cleaning and maintenance

6.1 Safety advice

o Before beginning with repair or cleaning works make sure the device has been
disconnected from power supply and has cooled down.
o Do not use any acid agents and make sure no water ingresses the device.
o To protect yourself from electric shock, never immerse the device, its cables and
the plug in water or other liquids.
CAUTION!
The device is not suited for direct washing via water jets.
Therefore, you must not use any kind of pressure water jet for cleaning the device!
- 26 -