Operation - Bartscher A200052 Mode D'emploi

5.3 Operation

•
For hygiene reasons, before first use fill the device with approx. 6 litres of water,
adjust for the highest temperature and boil for approx. 5 minutes. Then drain the
container.
•
After boiling, rinse the container with clean water and drain it again.
•
Clean the glass cover thoroughly with warm water and a mild cleaning agent. Then
rinse the cover with clean water and dry it thoroughly with the use of a soft cloth.
•
Adjust the temperature control in the „0" position.
CAUTION!
It is important that there is always drinkable liquid in the container before
engaging the device. You must not pour undrinkable liquids such as acids,
bases or leys, oils, nitrates etc. in the mulled wine pot/preserving pot.
•
Pour the desired drinkable liquid in the mulled wine pot/preserving pot. Minimum
filling quantity of 5 litres.
WARNING!
Never use the device when it is not filled with liquid!
•
Put the plug in the power socket (the red control light will go on).
WARNING! Hazard via electrical current!
During operation it must be ensured that no liquids can spill over as this can
cause short-circuits in the electronic control.
Personal injury can be the result.
Pay attention to the labels inside the container!
•
Before starting the device, put the glass cover so as to avoid temperature loss in
the container.
WARNING! Danger of burn!
During taking the lid off there is a danger of burn by the escaping steam and
condensate! Be particularly careful while doing this!
- 24 -