AEG SKS68848F1 Notice D'utilisation page 26

26 www.aeg.com
Problem
The lamp does not
work.
The compressor op-
erates continually.
The compressor
does not start imme-
diately after press-
ing the COOLMATIC
or FROSTMATIC
switch, or after
changing the tem-
perature.
Water flows on the
rear plate of the re-
frigerator.
Water flows into the
refrigerator.
Temperature cannot
be set .
The temperature in
the appliance is too
low/high.
Possible cause
The lamp is in stand-by.
The lamp is defective.
The temperature is not
set correctly.
The door is not closed
correctly.
The door has been
opened too frequently.
The product temperature
is too high.
The room temperature is
too high.
This is normal, no error
has occurred.
During the automatic de-
frosting process, frost de-
frosts on the rear plate.
The water outlet is clog-
ged.
Products prevent that wa-
ter flows into the water
collector.
COOLMATIC or FROST-
MATIC functions switched
on.
The temperature regula-
tor is not set correctly.
The door is not closed
correctly.
Solution
Close and open the door.
Refer to "Replacing the
lamp".
Set a higher temperature.
Refer to "Closing the
door".
Do not keep the door
open longer than necessa-
ry.
Let the product tempera-
ture decrease to room
temperature before stor-
age.
Decrease the room tem-
perature.
The compressor starts af-
ter a period of time.
This is correct.
Clean the water outlet.
Make sure that products
do not touch the rear
plate.
Switch off COOLMATIC or
FROSTMATIC manually, or
wait to set the temperature
until the function has reset
automatically. Refer to
"COOLMATIC or FROST-
MATIC function"..
Set a higher/lower temper-
ature.
Refer to "Closing the
door".