Bosch GOP 12V-28 Professional Notice Originale page 19

Application tool
HCS multi blade
Scraper, fixed
Scraper, flexible
Bi-metal segment
serrated blade
TC-Riff sanding fin-
ger
TC-Riff plunge cut
saw blade
HCS universal joint
cutter
Fitting/changing the application tool
Remove the application tool if one has already been fitted.
To remove the application tool, use the hex key (12) to
loosen the clamping bolt (11) and remove the tool.
Position the required application tool (e.g. plunge cut saw
blade (10)) on the tool holder (7) so that the depressed
centre is facing downwards (see figure on the graphics page,
text on the application tool should be legible from above).
Turn the application tool to a position which is convenient
for the job at hand and allow it to lock into place in the cams
Selecting a sanding sheet
Different sanding sheets are available, depending on the material you are working with and the required surface removal rate:
Sanding sheet Material
– All wood and wood-based
materials (e.g. hardwood,
softwood, chipboard, con-
struction boards)
– Metal materials
Bosch Power Tools
Material Application
Roofing felt, carpets, arti- Fast and precise cutting of soft material and flexible abras-
ficial turf, cardboard, PVC ive materials;
flooring example: Cutting carpets, cardboard, PVC flooring, roof-
ing felt, etc.
Carpets, mortar, con- Scraping on a hard surface;
crete, tile adhesive example: Removing mortar, tile adhesive, concrete
residue and carpet adhesive residue
Carpet adhesive, paint Flexible scraping on a soft surface;
residue, silicone example: Removing silicone joints, carpet adhesive
residue and paint residue
Insulation material, insula- Precise cutting of soft materials;
tion boards, floor panels, example: Cutting insulation boards to size, cutting pro-
impact sound insulation truding insulation material to length so that it is flush with
boards, cardboard, car- the surface
pets, rubber, leather
Wood, paint Sanding of wood or paint in hard-to-reach areas without
sanding paper;
example: Sanding off paint between window shutter slats,
sanding wooden flooring in corners
Fibreglass, mortar, wood Plunge cuts in extremely abrasive materials;
example: Routing of thin mosaic tiles
Expansion joints, window Cutting soft materials;
putty, insulation materials example: Cutting silicone expansion joints or window
(rock wool) putty
of the tool holder (7). Twelve positions offset by 30° are
possible for this.
Secure the application tool using the bolt (11). Tighten the
bolt using the hex key (12) until the rounded head of the bolt
is lying flat against the application tool.
Check that the application tool is seated securely. Ap-
u
plication tools that are attached incorrectly or are not se-
curely fixed in place may come loose during operation,
thereby putting you at risk.
Application
For pre-sanding, e.g. of rough and uneven beams and
boards
For surface sanding and levelling of slight irregularities
For finish-sanding and fine sanding of wood
English | 19
Grit
Coarse 40
60
Medium 80
100
120
Fine 180
240
320
400
1 609 92A 4A6 | (11.06.2018)