Télécharger Imprimer la page

Genesis GCS445SE Manuel D'utilisation page 4

Publicité

Les langues disponibles

Les langues disponibles

Do not use tool if switch does not turn it on or off.
with the switch is dangerous and must be repaired or replaced by an authorized service center.
Turn power tool off, and disconnect the plug
from the power tool before making any adjustments, changing the accessories, or storing the tools. Such
preventive safety measures reduce the risk of an accidental start up which may cause personal injury.
Store idle tool out of reach of children and other inexperienced persons
dangerous in the hand of untrained users.
Maintain power tools with care
component breaks, and any other conditions that may affect the tool's operation. A guard or any other part that
is damaged must be properly repaired or replaced by an authorized service center to avoid risk of personal
injury.
Use recommended accessories
manufacturer or intended for use on this type tool may cause damage to the tool or result in personal injury to
the user. Consult the operator's manual for recommended accessories.
Keep cutting tools sharp and clean
are less likely to bind and are easier to control.
Feed the work piece in the correct direction and speed.
blade, cutter, or abrasive surface against the direction of the cutting tool's direction of rotation only. Incorrectly
feeding the work piece in the same direction may cause the work piece to be thrown out at high speed.
Never leave the tool running unattended, turn the power off
until it comes to a complete stop.
Never start the power tool when any rotating component is in contact with
the work piece.
WArNING:
particles, including wood dust, crystalline silica dust and asbestos. Direct particles
away from face and body. Always operate tool in a well-ventilated area and provide
for proper dust removal. Use dust collection system wherever possible. Exposure
to the dust may cause serious and permanent respiratory or other injury, including
silicosis (a serious lung disease), cancer, and death. Avoid breathing the dust, and
avoid prolonged contact with the dust. Allowing dust to get into your mouth or eyes,
or lay on your skin may promote absorption of harmful material. Always use properly
fitting NIOSH/OSHA approved respiratory protection appropriate for dust exposure,
and wash exposed areas with soap and water.
SERVICE
• Have your power tool serviced by a qualified repair person
replacement parts. This will ensure that the safety of the power tool is maintained.
Service your power tool periodically
portion of the tool since internal wires may be misplaced or pinched.
EXTENSION COrDS
Grounded tools require a three wire extension cord
either a two or three wire extension cord. As the distance from the power supply outlet increases, you must use a
heavier gauge extension cord. using extension cords with inadequately sized wire causes a serious drop in voltage,
resulting in loss of power and possible tool damage. Refer to the table shown below to determine the required
minimum wire size.
The smaller the gauge number of the wire, the greater the capacity of the cord. for example: a 14-gauge cord can
carry a higher current than a 16-gauge cord. When using more than one extension cord to make up the total length,
be sure each cord contains at least the minimum wire size required. If you are using one extension cord for more
than one tool, add the nameplate amperes and use the sum to determine the required minimum wire size.
4-1/2" Compact Circular Saw
Operator's Manual
. Check for proper alignment and binding of moving parts,
. using accessories and attachments not recommended by the
Use of this tool can generate and disburse dust or other airborne
SAVE THESE INSTRUCTIONS
Any tool that cannot be controlled
from the power source and/or battery pack
. Properly maintained cutting tools with sharp cutting edges
. When cleaning a tool, be careful not to disassemble any
GCS445SE
feed the work piece into a
. Do not leave the tool
using only identical
.
Double insulated tools can use
. It is

Publicité

loading