Publicité
Les langues disponibles
Les langues disponibles
POCKET CUTS
A pocket cut is a cut that must be made inside the area of the work piece rather than starting from an outside
edge and working inward. Pocket cuts can be very dangerous for the novice to attempt because of the need to
manually retract the lower guard and perform a plunge cut which is potentially hazardous.
• Adjust the bevel setting to zero.
• Set the blade to the correct blade depth setting.
• Swing the lower blade guard up by using the lower blade guard lever.
NOTE:
Always raise the lower blade guard with the lever to avoid serious injury.
• Hold the lower blade guard by the lever.
• Rest the front of the base flat against the work piece with the rear part of the saw elevated so the blade does
not touch the work piece.
• Start the saw and let the blade reach full speed.
• Guide the saw down into the work piece and make the cut.
WArNING:
in the reverse direction could cause the saw to climb up on the work piece and back
toward you.
• Release the trigger and allow the blade to come to a complete stop.
• Lift the saw from the work piece.
• Repeat this procedure for the remaining sides, and then clear the corners out with a hand saw or jig saw.
WArNING:
blade exposed could lead to serious injury.
ACCESSOrIES
recommended accessories for this tool:
Model #
Image
GACSB451
GACSB452
4-1/2" Compact Circular Saw
Operator's Manual
Always cut in a forward direction when pocket cutting. Cutting
Never tie the lower blade guard in a raised position. Leaving the
Description
24 Teeth TCT Premium
Saw Balde
60 Teeth HSS Saw Balde
Appliaction
for cutting wood, plastic and other soft
materials
for cutting drywall, wood, aluminum
and other non-ferrous thin sheet metal
GCS445SE
Publicité
