Télécharger Imprimer la page

Genesis GLCS2055A Manuel D'utilisation page 7

Publicité

Les langues disponibles

Les langues disponibles

Do not leave the tool running.
When operating the tool from an elevated position,
beneath you.
Always hold the tool firmly in your hands before switching the tool "ON".
reaction to the torque of the motor as it accelerates to full speed may cause the tool to twist.
Wear eye and hearing protection.
otherwise specified, everyday glasses provide only limited impact resistance, they are not safety glasses.
use only certified safety equipment; eye protection equipment should comply with ANSI z87.1 standards.
Protective hearing equipment should comply with ANSI s3.19 standards.
Protect your lungs.
the risk of personal injury.
Always disconnect battery pack from tool
before any assembly, adjustments or changing of accessories. following this instruction will reduce the risk
of serious personal injury.
Do not place battery tools or their batteries near fire or heat.
risk of explosion and possibly personal injury.
Never use a battery which has been dropped or received a sharp blow.
damaged battery is subject to explosion. Properly dispose of a dropped or damaged battery immediately.
Use designated battery pack (Genesis™ - Model GLAB20HP or GLAB20A)
and charger (Genesis™ - Model GLACH20AS) for this tool.
batteries may result in a risk of fire.
IMPOrTANT SAFETY INSTrUCTIONS FOr CHArGEr &
BATTErY
Save these Instructions.
battery charger.
Before using the battery Charger,
Charger, (2) Battery, and (3) Product using battery.
Use only the charger
manual. Do not substitute any other charger.
Do not recharge battery in damp or wet environments
water or rain.
Do not operate charger with damaged cord or plug
Do not operate charger if it has received a sharp blow,
damaged in any way. Take it to a qualified serviceman.
Do not disassemble charger or battery pack.
service or repair is required. Incorrect reassembly may result in a risk of electric shock or fire.
Do not charge battery pack
Store tool and battery pack in a location where temperature will not exceed 122° f (50° C). This is important
to prevent serious damage to the battery cells.
Place charger on flat non-flammable surface
re-charging the battery pack.
To reduce risk of electric shock,
maintenance or cleaning.
f operating time has become excessively shorter,
• I
result in a risk of overheating, possible burns and even an explosion.
Battery leakage may occur
skin and eyes. If liquid comes in contact with your skin, wash immediately with soap and water. If liquid gets
into your eyes, wash them out with clear water for at least 10 minutes, and then seek medical attention right
away.
operate the tool only when hand-held.
Always use safety glasses with side shields. unless
Wear a face or dust mask if the operation is dusty. following this rule will reduce
SAVE THESE INSTRUCTIONS
This manual contains important safety and operating instructions for your
read all instructions and cautionary markings on (1) Battery
which accompanied your product or direct replacements as listed in this
when temperature is below 50° f (10° C) or above 104° f (40° C).
unplug charger from outlet before attempting any
under extreme usage or temperature conditions. Avoid contact with
be aware of people or things
or place the switch in the locked or off position
use of any other
. Do not expose battery pack to
. Replace immediately.
been dropped or otherwise
Take it to a qualified serviceman when
and away from flammable materials when
stop operating immediately. It may
The
This will reduce the
A
7

Publicité

loading