Original Accessories/Auxiliary Equipment; Before Initial Use; Charging The Battery Pack (See Fig. A); Attaching/Disconnecting The Battery Pack To/From The Device - Parkside PAHE 20-Li C3 Traduction Des Instructions D'origine

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 50
RESIDUAL RISKS!
Even if you operate this power tool properly,
there will still be residual risks. The following
risks can occur in the context of the design
and construction of this power tool:
a) Cuts
b) Hearing damage, if no suitable hearing
protection is worn.
c) Damage to health caused by hand-arm
vibrations if the appliance is used for
extended periods or is not properly used
and maintained.
WARNING!
Do not operate the appliance with a
damaged cable, power cable or power plug.
A damaged power cable causes danger to
life by electric shock.
Original accessories/auxiliary
equipment
Use only the additional equipment and acces-
sories detailed in the operating instructions.
The use of tools and accessories other than
those recommended in the operating instruc-
tions could lead to an increased risk of personal
injury for you.
GB │ IE
10 

Before initial use

Charging the battery pack
(see fig. A)
CAUTION!
Always unplug the appliance before you
remove the battery pack
the battery pack to the high-speed charger
Never charge the battery pack
ambient temperature is below 10°C or above
40°C.
Connect the battery pack
charger.
Insert the power plug into the mains power
socket. The red control LED
The green control LED
charging process is complete and the battery
pack
is ready for use.
CAUTION!
If the red control LED
that the battery pack
cannot be charged.
If the red and green control LEDs
flash simultaneously, this means that the
battery pack
is defective.
Fit the battery pack
Attaching/disconnecting the battery
pack to/from the device
Attaching the battery pack
Allow the battery pack
handle
of the appliance.
Removing the battery pack
Press the release button
battery pack
.
from or connect
when the
to the high-speed
will light up.
indicates that the
flashes, this means
has overheated and
back onto the appliance.
to click onto the rear
and remove the
PAHE 20-Li C3
.

Publicité

Table des Matières
loading

Table des Matières