Lubricating The Chain; Mounting The Saw Head On The Telescopic Handle; Sharpening The Saw Chain; Initial Use - Parkside PAHE 20-Li C3 Traduction Des Instructions D'origine

Lubricating the chain

♦ Remove the oil filler cap
♦ Fill the oil tank with approx. 65 ml of organic
chain oil .
WARNING!
► Never work without chain lubrication!
If the saw chain
equipment may become irreparably
damaged within a short time. Always check
chain lubrication and oil level
before starting work.
NOTE
► Use only saw chain oil. Preferably biodegrad-
able. Do not use waste oil, motor oil, etc.
► While working, check whether the automatic
chain lubrication is working correctly. Check
the chain lubricator before and during work.
Mounting the saw head on the
telescopic handle
♦ Place the lower end of the saw head
upper end of the telescopic handle
the saw head can be pushed through as far
13a
as the black plastic ring. Make sure that the
groove and the recess interlock with each other.
♦ Tighten the red connecting piece
it towards the symbol on the saw head
│ GB │ IE
■ 12
.
runs dry, the cutting
in the tank
on the
13a
so that
by turning
1a
13a

Sharpening the saw chain

NOTE
► You will find detailed information on
sharpening in the sharpening set.
► Alternatively, you can use an electrical saw
chain sharpening device and follow the
instructions of the manufacturer.
► If you have any doubts about implementing
the work, the saw chain
replaced.

Initial use

NOTE
► Comply with regulations regarding noise
protection and local rules. Using the appli-
ance on certain days (e.g. on Sundays and
public holidays), during certain times (midday
period, night time) or in certain locations
(e.g. health resorts, clinics, etc.) may be
restricted or prohibited.
Switching on and off
Switching on
♦ Press the safety lock-out
and then press the on/off switch
♦ After the starting process, the safety lock-out
can be released.
.
Switching off
♦ Release the ON/OFF switch
should be
and keep it pressed
.
.
PAHE 20-Li C3