Original Accessories/Auxiliary Equipment; Information On Saw Blades; Before Use; Charging The Battery Pack (See Fig. A) - Parkside PSSA 20-Li A1 Traduction Des Instructions D'origine

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 34
Original accessories/auxiliary
equipment
Use only the accessories and additional
equipment that are specified in the oper-
ating instructions and are compatible with
the appliance. Using attachments or accessory
tools other than those recommended in the
operating instructions can lead to a risk of injury.

Information on saw blades

You can use any saw blade provided it is fitted with
a suitable mount – ½" (12.7 mm) universal shaft.
Saw blades optimised for your sabre saw are avail-
able from retail stores in different lengths for
various purposes.
NOTE
TPI = teeth per inch = the number of teeth
per 2.54 cm
Wood saw blade
Dimensions: 152.5 x 0.9 mm, 6 - 12 TPI
Ideal for: sawing construction wood, chipboard,
panels and plywood, and also plunge cuts.
PSSA 20-Li A1

Before use

Charging the battery pack
(see fig. A)
CAUTION!
Always unplug the appliance before you
remove the battery pack from or connect the
battery pack to the charger.
NOTE
Never charge the battery pack if the ambient
temperature is below 10°C or above 40°C.
If a lithium-ion battery is to be stored for an
extended period, the charge level should be
checked regularly. The optimum charge level is
between 50% and 80%. The storage climate
should be cool and dry and the ambient
temperature should be between 0°C and
50°C.
Connect the battery pack
battery charger
Insert the power plug into the socket.
The control LED
The green LED
indicates that the charging
process is complete and the battery pack
ready.
ATTENTION!
If the red control LED
that the battery pack
cannot be charged.
If the red and green control LEDs
flash, this means that the battery pack
defective.
Push the battery pack
Switch off the charger
between successive charging sessions.
Also disconnect the power plug from the mains
power socket.
to the high-speed
(see fig. A).
lights up red.
flashes, this means
has overheated and
both
into the appliance.
for at least 15 minutes
GB │ IE
is
is
 7

Publicité

Table des Matières
loading

Table des Matières