Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
WMBUS ANALOG PWR - Guide utilisateur / User guide version V2.0.0
5.7. Starting up the product using a magnet
Once the product has been configured and its assembly has been finalised, the product is ready to be started up.
The start-up is carried out using a magnet which you place on the upper part of the product (cf. the diagram below). The magnet must be held
in position for at least 6 seconds so as to confirm the start-up of the product. When the magnet is well detected, the green LED lights up for 1
second.
Once the WMBUS ANALOG PWR unit validates its start-up, it immediately transmits status frames followed by a data frame (according the
defined periodicity).
NB : Once the WMBUS ANALOG PWR unit has started up, it cannot be switched off.
Position of the magnet for
starting up the product
FR
EN
Page
75
of 83
Publicité
Table des Matières
