Publicité
Les langues disponibles
Les langues disponibles
Model 6 buttons : the remote control allows the following operations:
4.7.1 Replacing the battery
The remote control (model with 4 buttons) comes without the battery;
it works with a battery placed in the lower part of the device.
To fit or replace the battery, proceed as follows:
- Open the cover on the back of the remote control;
- Replace the 12V battery model p23ga, respecting the polarity;
- Close the remote control;
- Check that it works properly;
The remote control (model with 6 button) is powered by a 3-volt CR2025 type battery (included) located in the
bottom of the device.
Also remove the insulation before use.
follows:
- Operate the lever indicated;
- Pull out the battery tray and replace the battery (3-volt CR2025 model) respecting the polarity;
- Insert the tray;
- Check proper functioning.
- Keep the remote control away from direct heat sources and water.
-The remote control battery must be replaced and disposed of safely in compliance
with local regulations;
Thermostat - external chronothermostat
4.8
The unit controls the room temperature by means of its own digital thermostat whose
function is to detect the temperature through a probe and lower the heat output when
the set temperature is reached.
To use an external thermostat, contact an authorised technician and proceed as
follows:
- turn off the power by means of the main switch on the back and detach the power
cable;
- remove the side panelling to access the electronic controller;
- referring to the wiring diagram, connect the two thermostat wires to the respective
board TERM terminals;
- refit everything and check correct operation.
Button P3: Stove lighting-shutdown
Button P1: Increase room temperature
Button P6: Increase output level
Button P5: Decrease output level
Button P2: Decrease room temperature
Button P4: Jolly
For its insertion and possible replacement, proceed as
battery tray
lever
58
TERMO-VIOLA
Publicité
