Last Calor TERMO-VIOLA Manuel D'installation, D'utilisation Et D'entretien page 57

4.6.4 Menu 04 – select language
With this selection it is possible to select the dialogue language
from those available entered in the menu, and namely:
- ITALIAN
- FRENCH
- ENGLISH
- GERMAN
4.6.5 Menu 05 – standby mode
With the selection of STANDBY mode
temperature or the water temperature has remained above the SET value for a fixed time.
The next automatic relighting will be possible only when the room temperature or the water temperature falls below
the set value entered in the parameters table (default 2°C).
The manual commands from the control panel or remote control have priority over programming.
With the selection off the stove does not activate the sleep-mode and functions normally activating the
MODULATION when the temperature exceeds the value of SET.
4.6.6 Menu 06 – buzzer
With this selection it is possible to activate/deactivate stove acoustic signalling.
4.6.7 Menu 07 – initial loading
The setting of LOAD INITIAL allows pellet preloading for a time equal to 90 sec. with the stove off or cold. It is
started with the button P1 and stopped with the button P4.
Button 'P1'
.
4.6.8 Menu 08 – stove status
With this selection it is possible to display the instantaneous stove status giving the operating status of the various
devices connected to it; various pages placed in succession are available for monitoring.
4.6.9 Menu 09 – settings by technician
This selection is reserved for the authorised technician of the COLA service centre.
Modification of the technical parameters of menu 09 must be done by authorised and competent
personnel; any changes made at random can cause serious damage for which COLA declines any
liability.
Remote control
4.7
The remote control works with the settings made in the control panel and allows stove lighting-shutdown, and
adjustment of the required output and temperature.
Since this device transmits through an infrared diode, it must be pointed at the receiver unit in the control panel.
Model 4 buttons -the remote control allows the following operations:
( ON selection ) the stove shuts down automatically after the room
L : LED lit up by pressing any button
Button P1+P6 : Stove lighting-shutdown
Button P1: Increase room temperature
Button P6: Increase output level
Button P5: Decrease output level
Button P2: Decrease room temperature
Button 'P4'
Menu level
57
TERMO-VIOLA