Westfalia Automotive 338 062 Notice De Montage Et D'utilisation page 25

Operating instructions for the detachable ball joint
Important!
There might be a light play of the ball joint in the receiver after using the tow bar. Therefore it is necessary to
check the following points to ensure correct locking of the detachable ball joint before each journey:
• The hair pin cotter (G) has to be inserted in the secure hole (F) of bolt (E).
• The ball joint (A) has to be fully inserted into the receiver (B) and be tight. Check by shaking it by
hand.
• The handle (H) has to be engaged in the lock (L).
Repeat the installation procedure if any of the 3 checks is not satisfactory.
To avoid the risk of accidents the towing device should not be used if any of the requirements is not met.
Contact your authorised Honda dealer if this occurs.
The ball joint can be easily installed and removed with the normal force of your hands.
Never use any sort of aids or tools etc. as this might damage the mechanism.
Never unlock if trailers are attached or load bearing implements mounted!
Always remove the ball joint and insert the plug into the receiver for journeys without a trailer or load bearing
implement. This is especially important if the tow ball impedes sight of the vehicle's registration number or
lights.
Notes!
Any repairs or dismantling of the detachable ball joint should only be carried out by an authorised Honda
dealer.
Fix the enclosed information plate to the car close to the receiver or inside the boot where it is clearly visible.
Always keep the ball joint and the receiver clean to ensure proper operation.
Ensure regular servicing of the mechanical parts. Lubricate the bearing points, friction surfaces and balls with
resin-free grease or oil. Grease and oil also function as additional protection against corrosion.
25