Operating Instructions; Maintenance And Care; Notes Regarding Environmental Protection; Contact Information - EUFAB 16457 Manuel De L'opérateur

6. OPERATING INSTRUCTIONS

INDUCTIVE RECEIVER

Remove your smartphone from the protective cover. Clean the back and the inside of the protective
cover to remove dust and grease. Connect the receiver to the charging port of your device. Place the
receiving antenna on the rear of your smartphone. Place the smartphone back into the protective
cover. Make sure that the feed cable and the antenna are not bent or damaged in any other way.
INDUCTIVE CHARGER
Place the inductive charger on the dashboard or centre
console of your vehicle. Choose as even a surface as possible. Pay
attention to the safety precautions detailed in section 4. Plug the
micro-USB-B connector of the charging cable into the charging
socket of the inductive charger, Figure 1.
Connect the USB connector of the charging cable to a USB port of
your vehicle or with a USB vehicle charger. The inductive charger
is now ready for use.
CHARGING
To charge, place your smartphone on the inductive charger. The charging process is started auto-
matically.
Separate the inductive charger from the on-board network of your vehicle when the
vehicle is switched off, otherwise the battery may be drained.

7. MAINTENANCE AND CARE

The set is maintenance-free if used according to its intended purpose.
After a longer period of use, dirt and dust will collect between the mobile device and
the protective cover. This may result in abrasions and scratches on the device. For this
reason, regularly clean the rear of the device and the inside of the protective cover.
Clean the inductive charger with a soft, dry cloth only. Do not use cleaning agents.

8. NOTES REGARDING ENVIRONMENTAL PROTECTION

Do not dispose of electrical devices with the household waste! Electrical and electronic
devices must be collected separately and sent for environmentally friendly recycling.
Please contact your community or city council regarding disposal options for electrical
and electronic scrap.

9. CONTACT INFORMATION

EAL GmbH
Otto-Hausmann-Ring 107
42115 Wuppertal
Germany
+49 (0)202 42 92 83 0
+49 (0) 202 42 92 83 – 160
Figure 1: Charging port
info@eal-vertrieb.com
www.eal-vertrieb.com
7