EINHELL HGG 120 NIRO Instructions De Service page 8

Anleitung HGG 120-300 NIRO
GB
Safety precautions Caution! Do not place the
heater on easily flammable
surfaces while in operation. (A
Please read the instructions
sheet metal plate is ideal) - fire
carefully before operating.
hazard -
Only use the hot-air generator
Make sure that the air inlet
in well ventilated areas and
grille and outlet grille of the fan
provide an adequate flow of
heater are always
fresh air. Do not use in
unobstructed and never
enclosed spaces.
covered.
If the temperature limiter
When you want to switch off
switches off during operation,
the appliance, it is imperative
the cause of overheating must
to turn the power switch to
be eliminated before using
„OFF" first. Never remove the
again. Air inflow or outflow
plug from the socket-outlet
restricted? Ventilator blocked?
before switching off.
The continuous presence of
persons in the room in which
If you discover a gas leak,
the heater is operating is not
close the valve on the gas
permitted.
bottle immediately. Turn off the
appliance and replace any
Only use the pressure
defective parts with new parts.
regulator which is delivered
with your unit (DIN 4811,
It is prohibited to use gas-
Section 1).
powered appliances in
basements or below ground
Do not use the heater without
level.
the covering cap.
Change the gas bottle only if
The room in which the heater
there are no sources of ignition
is used must be well ventilated.
near the appliance.
An opening to the outdoors of
6.5 cm 2 is required per
The appliance is not designed
250 kcal/h.
for home use.
The heater must not be placed
N.B.: If the HGG 120 is not
near any flammable materials,
equipped with a hose pipe
and no materials (even non-
breakage cut-out it may be
flammable items) should be
used for private purposes
stored within one meter of the
only. Commercial use of the
heater. (corresponds to
HGG 120 is only permitted
273 cm 2 at max. power)
when a hose pipe breakage
cut-out compliant with DIN
The diameter of the exhaust
30693, Art. No. 33.912.30 is
cone must never be reduced.
fitted!
Models HGG 200 + 300 are
If the heater performs poorly,
equipped as standard with an
please contact our customer
service division. integrated hose pipe
breakage cut-out.
Always unplug the heater
before any maintenance or
repairs.
Never place the gas cylinder in
front of the hot-air blower;
always place it to the side and
rear of the blower.
8
15.06.2004 11:42 Uhr Seite 8