Preparing For Use; Hot Air Frying - MOLINO health fryer Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 11
Construction
1.
Basket
2.
Handle
3.
Pan
4.
Air inlet
5.
Power-on light
6.
Heating-on light
7.
Plate
8.
Timer (0-60 min.)/ power-on knob
9.
Temperature control knob (80-200°C)
10.
Upper housing
11.
Main housing
12.
Power cord
13.
Base

Preparing for use

1.
Place the appliance on a stable, horizontal and level surface. Do not place the appliance on
non-heat-resistant surfaces.
2.
Place the basket in the pan properly.
3.
Slide the pan into the machine. Note: the pan MUST be put into the appliance properly,
otherwise the appliance doesn't work!
4.
Pull the mains cord and plug into the earthed wall socket. Do not fill the pan with oil or any
other liquid. Do not put anything on top of the appliance. Do not put anything on the air inlet
on the two sides of the appliance. This disrupts the airflow and affects the hot air frying
result.

Hot air frying

1.
Put the mains plug into an earthed wall socket.
2.
Carefully pull the pan out of the health fryer.
3.
Put the ingredients in the basket.
Note: never fill the basket in full or exceed the recommended amount (see section 'Set-
tings' in this chapter), as this could affect the quality of the end result.
4.
Slide the pan back into the Molino fryer properly.
Never use the pan without the basket in it. If the pan isn't fixed into the air fryer properly,
the appliance will not work! Caution: do not touch the pan during and sometime after use,
as it gets very hot. Only hold the pan by the handle.
5.
Turn the temperature control knob to the required temperature. See section 'Settings' to
determine the right temperature.
6.
Determine the required preparation time for the ingredient (see section 'Settings').
4
7.
To switch on the appliance, turn the timer knob to the required preparation time. Add 3
minutes to the preparation time when the appliance is cold.
Note: If you want, you can also let the appliance preheat without any ingredients inside.
In that case, turn the timer knob to more than 3 minutes and wait until the heating-up
light goes out after approx. 3 minutes. Then fill the basket and turn the timer knob to the
required preparation time.
a)
The power-on light and the heating-up light go on.
b)
The timer starts counting down the set preparation time.
c)
During the hot air frying process, the heating-up light comes on and switches off from
time to time. This indicates that the heating element is switched on and off to
maintain the set temperature.
d)
Excess oil from the ingredients which is collected on the bottom of the pan.
8.
Some ingredients require shaking halfway through the preparation time (see section 'Set-
tings'). To shake the ingredients, pull the pan out of the appliance by the handle and shake
it. Then slide the pan back into the air fryer and continue to cook.
Caution: Do not press the button of the handle during shaking.
Tip: To reduce the weight, you can remove the basket from the pan and shake the basket
only. To do so, pull the pan out of the appliance, place it on a heat-resistant surface and
press the button of the handle.
Tip: If you set the timer to half the preparation time, you hear the timer bell when you
have to shake the ingredients. However, this means that you have to set the timer again
to the remaining preparation time after shaking.
Tip: If you set the timer to full preparation time, there is no timer bell during cooking
before finishing, you can pull out the pan at any time to check the ingredients cooking
condition, the power will shut down automatically and resume after sliding the pan back
into the appliance (timer always counts down in this situation).
9.
When you hear the timer bell, the set preparation time has elapsed. Pull the pan out of the
appliance and place it on a heat-resistant surface.
Note: You can also switch off the appliance manually. To do this, turn the temperature
control knob to 0, or pull out the pan directly.
10. Check if the ingredients are ready. If the ingredients are not ready yet, simply slide the pan
back into the appliance and set the timer to a few extra minutes.
11. To remove small ingredients (e.g. fries), press the basket release button and lift the basket
out of the pan.
5

Publicité

Table des Matières
loading

Table des Matières