Black & Decker KS800S Mode D'emploi page 9

How to use the Auto Select
This tool is fitted with a unique Auto Select
applications. To select the optimum speed and pendulum blade action for the type of material being cut, turn the dial (8)
as shown in the table below:
Switching on and off
To switch the tool on, press the on/off switch (2).
To switch the tool off, release the on/off switch (2).
For continuous operation, press the lock-on button (1)
and release the on/off switch (2).
To switch the tool off when in continuous operation,
press the on/off switch (2) and release it.
Sawing
Hold the tool firmly with both hands while cutting.
The shoe plate (7) should be held firmly against the material
being cut. This will help prevent the saw from jumping,
reduce vibration and minimise blade breakage.
Let the blade run freely for a few seconds before starting
the cut.
Apply only a gentle pressure to the tool while performing
the cut.
TM
dial (fig. G)
TM
Dial (8) to set the speed and the pendulum blade action for various cutting
Icon Application Speed
Kitchen work surfaces, Fast speed
work tops, laminate
board
Scrolling/curves/ Fast speed
craftwork, hardwoods,
decking, flooring
Plywood and wood Fast speed
panels
General timber, soft Fast speed
wood, fast rip cutting
Plastics, Perspex, PVC Medium speed
Sheet metal tin plate, Low speed
ceramic tile, fibreglass
sheet
Slow speed, precision Slow speed
start
Operating the laser (fig. H - K) ('L' units only)
Installing the batteries (fig. H)
Detach the laser module (14) from the jigsaw by removing
the screw (13) and pulling the laser module forward. Insert
two new 1.5 Volt AAA alkaline batteries, making sure to
match the (+) and (-) terminals correctly. Re-attach the laser
module (14).
Adjusting the laser side-to-side (fig. I)
Note: The laser is intended as a cutting aid and does not
guarantee a precise cut.
Warning! Do not adjust the laser with the jigsaw plugged in.
Use the laser adjustment screw (15) to align the laser line
with the saw blade if needed.
ENGLISH
Blade Type
General wood
Scrolling wood
General wood
General wood
General wood
General purpose
Metal or ceramic or
fibreglass blade
Choose the correct
blade for the
application
9