Technical Specifications; Troubleshooting - Viking GE 103 Manuel D'utilisation

The product has been developed in
conformance with the following standards:
EN 50434, EN 60335-1
Applicable conformity assessment
procedure:
Appendix VIII (2000/14/EC)
Name and address of relevant, named
location:
TÜV Rheinland LGA Products GmbH
Tillystraße 2
D-90431 Nürnberg
Compilation and storage of technical
documentation:
Sven Zimmermann
VIKING GmbH
The year of manufacture and serial
number appear on the identification plate
of the machine.
Measured sound power level:
GE 103.1 100,2 dB(A)
GE 105.1 100,8 dB(A)
Guaranteed sound power level:
GE 103.1 103 dB(A)
GE 105.1 104 dB(A)
Langkampfen,
2015-01-02 (YYYY-MM-DD)
VIKING GmbH
Head of Design
0478 201 9910 D - EN

18. Technical specifications

GE 103.1/GE 105.1
manufacturer's VIKING
brand:
Power: 1800 W /
2200 W
Amperage rating: 8.7 A / 9.8 A
Rated voltage: 230 V
Frequency: 50 Hz
Speed: 2800 rpm
Fuses: 10 A / 16 A*
Protection class: I
Type of protection: Splash proof (IP
X4)
Operating conditions: P40
40 s load time
60 s idle time
Tightening torque 25 Nm
Bolt
Blade disc:
Tightening torque 10 Nm
Bolt
Reversible blade:
L/W/H: 77/48/97 cm
GE 103.1
In accordance with
Directive
2000/14/EC:
Guaranteed sound
power level L 103 dB(A)
WAd
In accordance with
Directive
2006/42/EC:
Sound pressure level
at workplace L 94 dB(A)
pA
Uncertainty K 3 dB(A)
pA
GE 103.1
Weight 17 kg
GE 105.1
In accordance with
Directive
2000/14/EC:
Guaranteed sound
power level L 104 dB(A)
WAd
In accordance with
Directive
2006/42/EC:
Sound pressure level
at workplace L 93 dB(A)
pA
Uncertainty K 3 dB(A)
pA
Weight 19 kg
19 kg (CH)
20 kg (GB)
* Caution!
In the case of mains fuses of less than
16 A, these may be tripped during start-
up or in the case of high load operation
of the machine.

19. Troubleshooting

If necessary, contact a specialist
dealer; VIKING recommends VIKING
specialist dealers.
Fault:
Motor does not start
Possible cause:
– Motor overload protection activated
– No mains voltage
– Electric cable, plug, plug connector or
switch defective
– Fuse in UK plug damaged (only applies
to machines for UK)
39