Water Connection - Nilfisk P 160.2-15 SUPER PRO X-TRA Notice D'utilisation

• It is recommended that the electrical supply to the ma-
FR
chine should include a residual current device that will in-
terrupt the supply if the leakage current to earth exceeds
EN
30 mA for 30 ms.
• Inadequate extension cables can be dangerous. If an ex-
tension cable is used, it shall be suitable for outdoor use,
and the connection has to be kept dry and off the ground.
• Nilfi sk recommends use of an extension cable drum
when cable extension is needed which keeps the socket
at least 60 mm above the ground.
• If the electric cable is damaged, it must be replaced by
an authorized Nilfi sk distributor or similar qualifi ed per-
son in order to avoid a hazard.
• Connecting the high pressure washer to a supply sys-
tem, the max allowed impedance is = 0,4023  (Zmax).
Consult with the supply authority that the equipment is
connected only to a supply of that impedance or less.

Water connection

• This high pressure washer is only allowed to be con-
nected with the drinking water mains, when an appro-
priate backfl ow preventer has been installed, Type BA
according to EN 60335-2-79.
• The backfl ow preventer can be ordered under number
106411177.
• As soon as drinking water has fl own through the back-
fl ow preventer, it is no longer regarded as drinking water.
• Operation by suction (e.g. a rainwater vessel) is carried
out without a backfl ow preventer – see "Connecting to
a pressureless water supply". The machine can be
connected to water mains with a max. inletpressure of 1
MPa/10 bars and max. 60°C.
Safety devices
Locking device on spray handle:
• The spray handle features a locking device. When the
pawl is activated, the spray handle cannot be ope rated.
Thermal sensor:
• A thermal sensor protects the motor against overloading.
The machine will restart after a few minutes when the
26
Original Instructions