Weighing; Resetting The Scales; Cleaning - ADE BE 1600 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 32

Weighing

Weighing
WARNING against injuries
− Do not step onto the scales with wet feet or when its surface is damp.
Risk of slipping!
− Position yourself on the scales. Remain standing still and do not hold on to
anything.
The scale switches on and the display flashes shortly afterwards: The measured
weight is shown in kilograms (KG).
A few seconds after you step off the weighing surface, the scales will switch off
automatically.
‚ The weight is displayed for up to approx. 10 seconds after leaving the
scale. When you step on the weighing platform using slight force, the
display shows „0.0" and you can weigh yourself again.
‚ Weigh yourself with as little clothing on as possible.
‚ Try to weigh yourself always at the same time and under consistent
conditions in order to obtain comparable values.

Resetting the scales

Reset the scales to factory settings if unusual or obviously incorrect values are shown
on the display.
1. Remove the batteries from the battery compartment and wait a moment.
2. Re-insert the batteries. Pay attention to the correct polarity of the batteries (+/-).
After switching the scales on, you can weigh yourself as usual.

Cleaning

NOTE on material damage
− Do not immerse the scales in water or other liquids.
− Do not under any circumstances use harsh, scraping, or abrasive clean-
ing agents or the like to clean the scales. If you do, the surface could
be scratched.
− Wipe down the scales as needed using a lightly dampened, soft cloth.
− Disinfect the weighing surface from time to time using a suitable disinfecting
agent (available at specialist retailers and pharmacies).
18
Bathroom Scales BE 1600

Publicité

Table des Matières
loading

Table des Matières