Inserting/Changing Batteries; Operation; Weighing - ADE Lucy Mode D'emploi

Inserting/changing batteries

For use you require 3 batteries of type LR03 (AAA), 1.5 V (included). The battery
compartment is located on the underside of the device.
1. Press the locking tab slightly towards the centre of the scales and remove the
battery compartment cover.
2. Insert the batteries as shown on the base of the battery compartment. Pay attention
to the correct polarity (+/-).
3. Put the battery compartment cover back in place. The locking tab must snap
securely into place.
Notes on changing the battery:
‚ The batteries need to be changed when "Lo" or nothing is shown on
the display.
‚ Only use the type of battery that is specified in the "Technical Data".
‚ Always exchange all of the batteries at the same time.
‚ Dispose of batteries in an environmentally appropriate way
(see "Disposal").

Operation

Weighing

1. Place the scales on an even, firm, and dry surface. Carefully position the scales in
order to avoid hard impacts to the sensors/feet and therefore to avoid damage.
2. Switch on the scales by pressing the /TARE button.
Wait a moment until "0" appears on the display.
3. Use the UNIT button to select the correct setting for the material to be weighed.
Note the display:
Solid material to be weighed
Weigh water
Weigh milk
To select between the different units of measure, hold down the UNIT
button for approx. 3 seconds.
‚ For solid material to be weighed: "g" (gram) and "lb:oz" (pound)
‚ For liquid material to be weighed: "ml" (millilitre) and "fl:oz" (fluid ounce)
Kitchen scales KE 1718 | KE 1719 | KE 1720 | KE 1721
Inserting/changing batteries
17