Inserting/Changing Batteries; Operation; Weighing - ADE Mira Mode D'emploi

Inserting/changing batteries

For use, you need 2 batteries of type LR03 (AAA), 1.5 V (included). The battery
compartment is located on the underside of the device.
1. Press the locking tab slightly towards the centre of the scale and remove the battery
compartment cover.
2. Insert the batteries as indicated at the bottom of the battery compartment. Pay
attention to the correct polarity (+/-).
3. Replace the battery compartment cover. The locking tab must snap securely into
place.
Notes on changing the battery:
‚ Battery change is necessary if the display shows either a battery
symbol, "Lo" or nothing at all.
‚ Only use the type of battery that is specified in the "Technical data".
‚ Always change all batteries at the same time.
‚ Dispose of old batteries in an environmentally appropriate way
(see "Disposal").

Operation

Weighing

1. Place the scale on an even, firm, and dry surface. Carefully position the scale in order
to avoid hard shocks to the sensors/feet and therefore any damage.
2. Press OFF/TARE to switch on the scale.
3. Choose the desired unit of measurement by repeatedly tapping UNIT. You can
choose between "g" (gramme), "lboz" (pound), "oz" (ounce) and "ml" (millilitre).
Pay attention to the indication on the display.
Choose "ml" if you would like to weigh liquids.
4. If you want to weigh an item or substance in a container, now place the container
without anything in it onto the weighing surface. Otherwise, proceed as described
in Section 6.
5. Press OFF/TARE.
The display will show "0 g", "0:00 lboz", "0.00 oz" or "0 ml" and "TARE" depending on
the selected unit of measurement.
6. Put the item or substance to be weighed into the container or place it onto the
weighing surface.
The measured weight is shown on the display.
Digital Kitchen Scale KE 1733
Inserting/changing batteries
17