DeWalt DW715 Guide D'utilisation page 7

or thicker plywood which can then be clamped to your work support or moved to other job
sites and reclamped.
NOTE: If you elect to mount your saw to a piece of plywood, make sure that the mounting
screws don't protrude from the bottom of the wood. The plywood must sit flush on the work
support. When clamping the saw to any work surface, clamp only on the clamping bosses
where the mounting screw holes are located. Clamping at any other point will surely interfere
with the proper operation of the saw.
CAUTION: To prevent binding and inaccuracy, be sure the mounting surface is not warped
or otherwise uneven. If the saw rocks on the surface place a thin piece of material under one
saw foot until the saw sits firmly on the mounting surface.
IMPORTANT SAFETY INSTRUCTIONS
FIG. 2
CARRY
HANDLE
LOCK
DOWN
PIN
LEFT SIDE
FENCE
FENCE
LOCK
KNOB
BLADE
WRENCH
BENCH
MOUNTING
HOLES
MITER
HAND
SCALE
INDENTATIONS
TRIGGER
SWITCH
OPERATING
HANDLE
MOTOR
END CAP
MOTOR
HOUSING
GUARD
KERF
BEVEL SCALE
PLATE
BENCH
MOUNTING
HOLES
MITER
LOCK LEVER
MITER
LATCH
Changing or Installing a New Saw Blade (Fig. 3)
WARNING: To reduce the risk of serious personal injury, turn off the tool and
disconnect it from the power source before attempting to move it, change
accessories or make any adjustments.
CAUTION:
• Never depress the spindle lock button while the blade is under power or coasting.
• Do not cut ferrous metal (containing iron or steel) or masonry or fiber cement product
with this miter saw.
Removing the Blade (Fig. 3, 3A)
1. Unplug the saw.
2. Raise the arm to the upper position and raise the lower guard (A) as far as possible.
CARRY
HANDLE
DUST SPOUT
45° BEVEL STOP
ADJUSTMENT
SCREW
BEVEL LOCK
KNOB
0°/45° BEVEL
OVERRIDE
LEVERS
BEVEL STOP BEVEL STOP
ADJUSTMENT
A 33,85° PAWL
SCREW
5
LOCK DOWN
LEFT SIDE
PIN
FENCE
FENCE LOCK
KNOB
HAND
INDENTATIONS
0°
BLADE
WRENCH