Stopping The Twistorr 305-Ic; Emergency Stop - Agilent Technologies TwisTorr 305-IC Mode D'emploi

7 Instructions for Use

Stopping the TwisTorr 305-IC

Stopping the TwisTorr 305-IC

To stop the 305-IC, not in emergency, it is necessary to:
a) if the 305-IC is configured in REMOTE MODE, and the INTERLOCK is set to
b) if the 305-IC is configured in REMOTE MODE, and the INTERLOCK is set to
c) if the 305-IC is configured in SERIAL Mode, then send a STOP command to

Emergency stop

Emergency stop can be achieved by removing the power supply.
WARNING! This mode is to be used only in an emergency. The use of this stop mode
could lead to faults and/or damages at the pump. Improper use of this stop
mode could void the warranty.
220/302
CONTINUOUS MODE, then open the "START" or the "INTERLOCK" signals;
IMPULSE MODE, then open the START signal;
the 305-IC.
TwisTorr 305-IC User Manual / 87-901-058-01