Stopping The Twistorr 305 Fs; Emergency Stop - Agilent Technologies TwisTorr 305 FS Notice De Mode D'emploi

7 Instructions for Use
Startup and Operation of the TwisTorr 305 FS

Stopping the TwisTorr 305 FS

To stop the pump while it is running, in is necessary to act on the control unit
which is driving the pump and which is connected to it.
It is possible to stop the pump via serial comm. commands as well as via
Remote I/O signals.
Please refer to the controller's relevant instruction manuals in order to find the
appropriate set of instructions (Remote: Chapter Technical Information -
Controller Connection & Window Meanings; On Board: Chapter Technical
Information - Interconnections & Window Meanings).

Emergency stop

Emergency stop can be achieved by removing the power supply.
WARNING! This mode is to be used only in an emergency. The use of this stop mode
could lead to faults and/or damages at the pump. Improper use of this stop
mode could void the warranty.
206/258 TwisTorr 305 FS User Manual / 87-901-057-01 (A.00)