Window Description - Agilent Technologies TwisTorr 305-IC Mode D'emploi

Window Description

WIN # READ WRITE
0 Always Serial
1 Always Serial
8 Always Always
100 Always Stop & Serial
101 Always Always
102 Always Always
103 Always Always
104 Always Always
105 Always Always
108 Always Always
109 Always Always
110 Always Always
111 Always Always
117 Always Always
120 Always Always
121 Always Always
122 Always Always
125 Always Always
126 Always Always
TwisTorr 305-IC User Manual / 87-901-058-01
TYPE NAME
L Start/Stop
L Low Speed
A Serial/Remote
L Soft Start
N Setpoint Type
N Setpoint Value
N Setpoint Delay
L Setpoint Logic
N Setpoint histeresis
N Baud Rate
L Pump Life Reset
L Interlock Type
N Analog Output Type
N Low Speed Adjust Frequency
N Target Frequency
N Maximum frequency
L Set vent valve
A Set the vent valve operation
N Vent valve opening delay
Technical Information

Window Description

MEANING
Start/Stop command
Low Speed command
Configures controller
Enable/Disable Soft Start option
It defines set point type:
0 = Freqency
1 = Power
2 = Time
3 = Normal
It defines the threshold value for Set Point
It defines the setpoint mask time from start
It defines the functionally logic. "High level active"
indicates an output ON when the signal is above the
threshold and "Low level active" is the opposite.
It defines the percentage value of Set Point Hysteresis
It defines the serial communication baud rate:
0 = 600 bit/s
1 = 1200 bit/s
2 = 2400 bit/s
3 = 4800 bit/s
4 = 9600 bit/s
5 = 19200 bit/s
6 = 38400 bit/s
Pump Life Reset
It defines the interlock type. The interlock can be checked
at start or continuously
It defines the analog output type:
0 = Frequency (10V = OMEGA_MAX_ABS)
1 = Power (10V = P_RANGE)
2 = Body Temperature (10V = 125°C)
It defines the Low Speed frequency value
It defines the target excitation frequency
It defines the maximum frequency settable by WIN120
Set vent valve
Set the vent valve operation
0 = Automatic
1 = On command
Vent valve opening delay (expressed in 0.2sec)
8
281/302