Husqvarna 343F Manuel D'utilisation page 59

throttle function is now activated. To return the engine to idle,
press the throttle lockout and throttle trigger again.
Decompression valve
If the machine is fitted with a decompression valve (A): Press
the valve to reduce the pressure in the cylinder and make
starting easier. You should always use the decompression
valve when starting the machine. Once the machine has
started the valve will automatically return to its original
setting.
Starting
WARNING! When the engine is started with
!
the choke in either the choke or start
throttle positions the cutting attachment
will start to rotate immediately.
Hold the body of the machine on the ground using your left
hand (CAUTION! Not with your foot!). Grip the starter
handle, slowly pull out the cord with your right hand until you
feel some resistance (the starter pawls grip), now quickly
and powerfully pull the cord. Never wrap the starter cord
around your hand
Repeat pulling the cord until the engine starts. When the
engine starts. return choke control to run position and apply
full throttle; the throttle will automatically disengage from the
start setting.
CAUTION! Do not pull the starter cord all the way out and
do not let go of the starter handle when the cord is fully
extended. This can damage the machine.
STARTING AND STOPPING
Stopping
343FR, 343FRM, 343R, 345RX
Stop the engine by switching off the ignition.
343F, 345FX, 345FXT
Heated handles
(345FXT)
Models equipped with heating elements in the handles have
an on/off switch on the throttle handle to control the heat.
Both the left and right handles have heating elements that
automatically maintain a temperature of roughly 70° when
the heat is turned on.
–
English 59