DeWalt D55168 Guide D'utilisation page 17

GLOSSArY
CFM: Cubic feet per minute.
sCFM: Standard cubic feet per minute; a unit of measure of air delivery.
PsI: Pounds per square inch; a unit of measure of pressure.
kPa (kilopascal): Metric pressure measurement. 1 kilopascal equal 1000 pascals.
Code Certification: Products that bear one or more of the following marks: UL
*, CUL, ETL *, CETL, have been evaluated by OSHA
® ®
certified independent safety laboratories and meet the applicable Standards for Safety.
*UL is a registered trademark of Underwriters Laboratories and ETL is a registered trademark of Electrical Testing Laboratories.
® ®
Cut-In Pressure: While the motor is off, air tank pressure drops when accessory is used. When the tank pressure drops to a certain low
level the motor will restart automatically. The low pressure at which the motor automatically restarts is called cut-in pressure.
Cut-Out Pressure: When an air compressor is turned on and begins to run, air pressure in the air tank begins to build. It builds to a
certain high pressure before the motor automatically shuts off, protecting your air tank from pressure higher than its capacity. The high
pressure at which the motor shuts off is called cut-out pressure.
Branch Circuit: The circuit carrying electricity from electrical panel to outlet.
Duty Cycle: This air compressor pump is capable of running continuously. However, to prolong the life of your air compressor, it is
recommended that a 50%-75% average duty cycle be maintained; that is, the air compressor pump should not run more than 30-45 minutes
in any given hour.
17