Maintenance, Cleaning And Stroage; Cleaning; Stroage Instructions - IKRA BRM 1040 Manuel D'utilisation

3. MAINTENANCE, CLEANING AND
STROAGE
WARNING!
Stop the engine and unplug the spark plug before
any repairing or maintenance operations
• Refer to separate engine manual for engine mainte-
nance instructions.
• Stop the engine and unplug the spark plug before any
repairing or maintenance operations.
• For four strokes engine read carefully the maintenance
engine manual. Check regularly the oil level and add
some oil or replace it if necessary.
• Frequently check the lawnmower and ensure that all
grass deposits are removed from beneath the deck.
• Lubricate regularly the wheel axle and the bearings
with grease.
• Check often the blade, in order to obtain a clean work
the blade should always be sharp and well balance.
• At regularly intervals check the tightening of all bolts
and screws. Wear off or badly tightening nuts and bolts
can involve some important damages to the engine or
the frame.
• If the blade hits violently an obstacle, stop the lawnmo-
wer and bring it to agreed service station.
THE BLADE: The blade is made of pressed steel, in or-
der to obtain a clean work sharpen the blade frequently,
around every 25hours of work. Be sure that the blade is
always well balance.
YOU MUST ONLY USE THE MANUFACTURER BALDE
IT SHOULD BE REFERENCED AND WEAR THE MA-
NUFACTURER BRAND "BRM 1040"!
To remove the blade, unscrew the screw, check the blade
support and change all spare parts if they are worn out
or damaged.
When reassembling the blade, make sure that the
cutting edges face in the direction of the engine rotation.
The blade screw must be torque to 3.7 K•gm(37Nm) with
a dynamometric tool.
ONLY USE ORIGINAL SPARE PARTS. SPARE
PART OF BAD QUALITY CAN INVOLVE IMPORTANT
DAMAGES TO YOUR LAWNMOWER AND BEPREJU-
DICIAL FOR YOUR SECURITY.
GB | Operating Instruction

3.1 CLEANING

engine or contaminate the fuel system.
1. Wipe deck with dry cloth.
2. Hose under deck by tilting the mower so that the
3. Refer to separate engine manual for engine cleaning

3.2 STROAGE INSTRUCTIONS

The following steps should be taken to prepare lawn mo-
wer for storage.
1. Following the final cut of the season allow the fuel
2. Clean and lubricate mower thoroughly as described
3. Refer to engine manual for correct engine storage
4. Lightly coat mower's cutting blade with chassis gre-
5. Store mower in a dry, clean area.
• When storing any type of power equipment in an un-
ventilated or material storageshed.
• Care should be taken to rust-proof the equipment.
Using a light oil or silicone,coat the equipment, espe-
cially cables and all moving parts.
• Be careful not to bend or kink cables.
• If the starter rope becomes disconnected from rope
guide on handle, disconnect and ground the spark
plug wire, Depress the blade control handle and pull
the starter rope out from engine slowly. Slip the starter
rope into the rope guide bolt on handle.
7
CAUTION: Do not hose engine. Water can damage
spark plug is up.
instructions.
tank to run dry.
in the lubrication instructions.
instructions.
ase to prevent rusting.
NOTE: