Engine Starting; Stop The Engine And Machine; Grass Catcher; Cutting Height Adjustment - IKRA BRM 1040 Manuel D'utilisation

illustration 5
1. To fit: Raise the rear cover and hitch the grass bag on
rear of mower. (Fig. 4,Fig. 5)
2. To remove: grasp and lift the rear cover, remove grass
bag.
Before using the machine you must read the separa-
ted Engine instruction book carefully and service the
engine with gasoline and oil.

ENGINE STARTING

Once the machine has been serviced properly, start the
engine as follow.
1. Standing behind the unit, grasp the brake control
handle and hold it against the upper handle as shown
in figure followed.(fig. 6)
2. Grasp the brake control handles as shown followed
figure and pull up rapidly. Return it slowly to the rope
guide after engine starts. Release the brake control
handle can stop the engine and blade.
illustration 6
Blade is in action as soon as engine started. While
the machine is working maintain the brake control
handle in working position. The engine will stop as
soon as you release the brake control handle.
GB | Operating Instruction
When starting a new engine for the first time, firmly push
the yellow primer five times. Then for all future starts,
push the primer three times.
Note: If engine runs out of fuel or has been stored for an
extended period of time, it may be necessary to prime
5 times.
Note: Priming is usually unnecessary when restarting a
warm engine.
Note: If you push the primer too many times, an excessi-
ve amount of fuel will flood the engine. This flooded con-
dition will make the engine difficult to start.

STOP THE ENGINE AND MACHINE

Release the break control handle to stop the engine and
blade, thus stopping the lawnmower from operating.

GRASS CATCHER

Empty and clean the bag, make sure it is clean and ensu-
re its meshwork is ventilated.

CUTTING HEIGHT ADJUSTMENT

Apply outward pressure to disengage lever from rack,
move lever forward or back to adjust height.
6
Attention: