Before You Begin; Tools And Parts Needed; Parts Included; Appliance Dimensions - Gaggenau AI 230 700 Notice D'utilisation Et De Montage

Before you begin

Tools and parts needed

▯
Measuring tape
▯
Pencil
▯
Torx screwdriver TX20
▯
Drill with the following bits: 5/16" (8 mm)
▯
Spirit-level
▯
Aluminum tape (DO NOT use insulating tape)
▯
Exhaust channel (configuration depends on the
installation situation)
▯
Additional sheet metal screws (if necessary for
installation of the exhaust air duct)

Parts included

B e f o r e y o u b e g i n

Appliance dimensions

▯
This appliance is fitted to the kitchen ceiling or a
stable suspended ceiling.
▯
Check the position of the screws using the
enclosed template.
▯
Follow the enclosed installation instructions for
additional special accessories (e.g. for
circulating-air mode).
▯
The surfaces of the appliance are sensitive.
Avoid damaging them during installation.

Safety clearances

9
WARNING
Risk of fire
Grease deposits in the grease filter may catch
fire. The specified safety distances must be
observed in order to prevent an accumulation
of heat. Observe the specifications for your
cooking appliance. If gas and electric
cooktops are operated together, the largest
specified distance applies.
Only one side of the appliance may be
installed directly next to a high-sided unit or a
wall. The distance between the appliance and
wall or high-sided unit must be at least 2"
(50 mm).
The minimum distance between the supporting
surface for the cooking equipment on the hob and
the lowest part of the range hood must be not less
than 30 " (760 mm) from electric cookers and 30 "
(760 mm) from gas or mixed cookers.
If the instructions for installation for the gas hob
specify a greater distance, this must be adhered to.
17