Electrical Connection; Installation; Fitting The Upper Support Frame - Gaggenau AI 230 700 Notice D'utilisation Et De Montage

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Electrical connection

9
WARNING
Risk of electric shock
Parts inside the appliance can have sharp
edges. The connection cable can be damaged.
Do not bend or pinch connection cables
during installation.
The necessary connection information is located on
the identification plate in the appliance interior,
remove metal grease filter to access it.
Length of the connecting cable: Approx. 4
(1.30 m)
This appliance meets EC radio interference
suppression requirements.
9
WARNING
Risk of electric shock
It must always be possible to disconnect the
appliance from the power supply. The
appliance must only be connected to a
protective contact socket that has been
correctly installed.
The plug of the electric power cable must be
easily accessible after installation of the
appliance. If this is not possible, an all-pole
isolating switch must be integrated into the
permanent electrical installation according to
the conditions of overvoltage category III and
according to the installation regulations.
The permanent electrical installation must only
be wired by a professional electrician. We
recommend installing a residual-current circuit
breaker (RCCB) in the appliance's power
supply circuit.

Installation

Fitting the upper support frame

1
Before installation, specify the total height of the
support frame and mark the screw holes.
Note: The height of the support frame can be
adjusted in
2
On the ceiling mark the center point of the
appliance.
3
Using the enclosed template, mark the positions
for the screws on the ceiling.
]
ft
4
Drill four
" (80 mm) for the attachments and press in the
32
wall plugs flush with the wall.
5
Attach the upper part of the support frame to the
ceiling with 4 screws.
Note: Ensure that the support frame is in the
correct position. The middle bracket defines the
preferred side and must be facing the control
element for the cooktop.
/
" (20 mm) steps.
3
4
/
" (8 mm) Ø holes to a depth of 3
5
16
/
5
19

Publicité

Table des Matières
loading

Table des Matières