Fitting The Lower Support Frame; Installing The Appliance - Gaggenau AI 230 700 Notice D'utilisation Et De Montage

Fitting the lower support frame

Attach upper and lower parts of the support frame at
the specified total height using 10 screws.
Notes
‒ Ensure that the lower support frame is in the
correct position. The open side must be facing
the control element of the cooktop.
‒ The support frame can be re-aligned by
loosening the fastening screws.

Installing the appliance

1 Hook the appliance from below into the support
frame.
Note: Ensure that the mains cable is not
trapped.
20
2 Attach the appliance to the support frame using
2 fastening screws.
3 Hook in retaining clip and screw tight.
Connecting the pipes
Note: If an aluminum pipe is used, smooth the
connection area beforehand.
Exhaust-air pipe Ø 6" (150 mm) (recommended size)
Attach exhaust-air pipe directly to the air-pipe
connector and seal.
_
Exhaust-air pipe Ø 4
1 Attach reducing connector directly to the air-
pipe connector.
2 Attach exhaust air pipe to the reducing
connector.
3 Seal both joints appropriately.
" (120 mm)