Electrical Connection - Gaggenau AW 482 Notice De Montage

Circulating-air mode
Place the reducing connecting piece onto the air
connecting piece – Fig. 4 – and fasten the exhaust
pipe to it.
If the extractor hood is suitable for circulating-air
mode, you can puchase the complete installation set
at specialist outlets.
Preparing the wall
The wall must be flat and perpendicular.
Ensure that the wall is capable of providing a firm
hold for mounting screws and plugs.
Installation
The extractor hood is intended to be mounted onto
the kitchen wall.
1 Remove the edge extraction segments and the
grease filters (as described in the operating
instructions).
2 Mark the 2 centrelines on the flues from the ceiling to
the lower edge of the hood, as indicated on the
template.
3 Use the template to mark the points on the wall where
the screws will be mounted. In order to make it easier
to hook the hood onto the screws, draw the outline of
the area where the hood will be attached. Fig. 5
Ensure that the minimum distance between the hob
and the extractor hood is maintained – 550 mm for an
electric hob and 650 mm for a gas hob. The bottom
edge of the template equates to the lower edge of the
extractor hood.
Drill 8 mm ∅ holes for the extractor hood and for the
4
flue duct and insert wall plugs flush whith the wall.
5 Screw on the mounting hooks with the angled part
facing outwards.
6 Screw the support screws.
7 Rest the back of the hood on the wall and let the
hood enter the corresponding slots.
8 Using a screwdriver, slowly tighten the screws which
position the hood horizontally until the extractor hood
is situated horizontally over the hob. Fig.6.
9 Insert and fix with the screw-driver the safety screws.
10 Insert the screws into the holes of the flue brackets
andtighten firmly.
11 Connect the hood to electricity supply.
12 Connect the air outlet pipe.
13 For each pair of flues:
Attach the 2 parts of the flue, the upper part to the
flue bracket with 2 screws and the lower part to the
hood structure with 2 screws.

Electrical connection

The extractor hood should only be connected to an
earthed socket that has been installed according to
relevant regulations. If possible site the earthed socket
directly behind the chimney panelling.
Risk of electric shock!
The appliance features an EU safety plug. To ensure
protective earthing in a Danish socket, the appliance must
be connected to a suitable plug adapter. This adapter
(permitted up to max. 13 amps) is available from customer
service (spare part no. 616581).
Electrical Data:
Are to be found on the name plate inside the appliance
after removal of the filter frame. Before undertaking any
repairs, always disconnect the extractor hood from the
electricity supply.
Length of the connecting cable: 1,3 m
If it is necessary to wire the extractor hood directly into
the mains:
The extractor hood should only be connected to the
electricity supply by a properly qualified electrician.
A separator must be installed in the household circuit. A
suitable separator is a switch that has a contact gap of
more than 3 mm and interrupts all poles. Such devices
include circuit breakers and contactors.
If the connection cable for this appliance is damaged, the
cable must be replaced by the manufacturer or his
customer service or a similarly qualified person in order to
prevent serious inury to the user.
This extractor corresponds to EC regulations concerning
RF interference suppression.
WARNING: THIS APPLIANCE MUST BE EARTHED.
IMPORTANT: Fitting a different plug.
The wires in the mains lead are coloured in accordance
with the following code:
Green and Yellow – Earth
Blue – Neutral
Brown – Live
If you fit your own plug, the colours of these wires may
not correspond with the identifying marks on the plug
terminals.
9