Electrical Connection; Before You Begin; Tools And Parts Needed; Parts Included - Gaggenau AI 442 720 Notice De Montage

Electrical connection

9
WARNING
Risk of electric shock
Parts inside the appliance can have sharp edges.
The connection cable can be damaged. Do not
bend or pinch connection cables during
installation.
The required connection information is on the
appliance's identification plate.
This appliance meets EC radio interference
suppression requirements.
This appliance may only be connected to a correctly
installed grounded socket.
Attach the grounded socket inside the flue duct if
possible.
▯
The grounded socket should be connected via its
own circuit.
▯
If the grounded socket is no longer accessible after
installing the appliance, an all-pole isolating switch
(e.g. circuit breaker, fuses, and contactors) with at
least a 3 mm contact gap must be included in the
installation.

Before you begin

Tools and parts needed

▯
Measuring tape
▯
Pencil
▯
Torx screwdriver TX20
▯
Drill with the following bits: 5/16" (8 mm)
▯
Spanner, 7 mm
▯
Spirit-level
▯
Aluminum tape (DO NOT use insulating tape)
▯
Exhaust channel (configuration depends on the
installation situation)
▯
Additional sheet metal screws (if necessary for
installation of the exhaust air duct)

Parts included

All models
B e f o r e y o u b e g i n
7