Safety Clearances; Installation; Appliance Handling Safety; Transport Securing Device - Gaggenau AI 442 720 Notice De Montage

Safety clearances

9
WARNING
Risk of fire
Grease deposits in the grease filter may catch
fire. The specified safety distances must be
observed in order to prevent an accumulation of
heat. Observe the specifications for your cooking
appliance. If gas and electric cooktops are
operated together, the largest specified distance
applies.
Only one side of the appliance may be installed
directly next to a high-sided unit or a wall. The
distance between the appliance and wall or high-
sided unit must be at least 2" (50 mm).
The minimum distance between the supporting surface
for the cooking equipment on the hob and the lowest
part of the range hood must be not less than 30 "
(760 mm) from electric cookers and 30 " (760 mm) from
gas or mixed cookers.
If the instructions for installation for the gas hob specify
a greater distance, this must be adhered to.
10

Installation

Appliance Handling Safety

Unit is heavy and requires at least two people or proper
equipment to move.
Hidden surfaces may have sharp edges. Use caution
when reaching behind or under appliance.

Transport securing device

The supporting frame is secured for transport using
self-tapping screws. Remove these self-tapping screws
before installation.

Fitting the upper support frame

1 Before installation, establish the total height of the
support frame.
Note: The height of the support frame can be
adjusted in steps of ¾" (20 mm).
2 Mark the positions of the six screws on the ceiling.
Note: Ensure that the support frame is in the
correct position. The appliance has one control
panel on the open side of the support frame. The
other control panel is located on the opposite side.
3 Drill the holes and push in the wall plugs so that
they are flush with the wall.