Velleman DVM94 Mode D'emploi page 6

Always be careful when working with voltages above 60 VDC or 30 VAC
•
rms. Keep your fingers behind the probe barriers at all times during
measurement.
Never perform resistance, diode or continuity measurements on live
•
circuits. Make sure all capacitors in the circuit are depleted.
6. General Description
This device is a battery-operated, hand-held 3 ½ digital multi-meter for
measuring DC and AC voltages, DC current and resistance. It also offers the
possibility of testing continuity, diodes and batteries.
Refer to the illustration on page 2 of this manual:
1. Display
3 ½ digits, 7 segments, LCD: 45 x 18 mm
2.
Hold button
In any range, press this button to freeze the last reading. Press again
to unfreeze.
3.
Rotary switch
This switch is used to select functions and desired ranges as well as to
turn the meter on/off.
4. "10A" jack
Insert the red test lead in this connector in order to measure a max.
current of 10 A.
5. "COM" jack
Insert the black (negative) test lead.
6.
"VΩmA" jack
Insert the red (positive) test lead in this connector to measure voltage,
resistance and current (except 10 A).
7. Overvoltage/Installation Category
DMMs are categorized depending on the risk and severity of transient
overvoltage that might occur at the point of test. Transients are short-lived
bursts of energy induced in a system, e.g. caused by lightning strike on a
power line.
The existing categories according EN 61010-1 are:
A CAT I-rated meter is suitable for measurements on protected
CAT I electronic circuits that are not directly connected to mains power, e.g.
electronics circuits, control signals...
V. 02 – 02/09/2016
DVM94
6 ©Velleman nv