Zibro Tosca Manuel D'utilisation page 98

When day of the week in UT 01 is programmed as "Off" programme 1 is switched
off.
setting the week timer for programme 2.
1. Press P3 as many times until display A shows "UT08"
2. S et the starting time for programme 2 using P1 and P2. The starting time is
3. P ress P3 again, display A will now show "UT 09" and the off time can now be
4. Set the off time using P1 and P2. The off time is shown in display B
5. P ress P3 again, display A will now show "UT 10". Per day of the week can now
6. D isplay B will now show either "off" or "on" followed by a number. (for exam-
7. W hether programme 2 is applicable on a certain day can be changed by press-
8. W ith P1 can be toggled through the days of the week until the day is reached
An example of a programme 2 cycle after programming could be:
Display B
When day of the week in UT 01 is programmed as "Off" programme 2 is switched
off.
D.12 The FUeL
Only use wood pellets of good quality with a diameter of 6 mm and a maximum
length of 30 mm. Different kind of wood pellets with different characteristics and
quality can be found on the market. Good quality wood pellets can be recognized
in the following way:
•
•
•
•
•
•
•
4
98
shown in display B.
programmed
be defined whether the stove must turn on/off at the moments defined at "UT
08" and "UT 09".
ple "on 2" or "on 5" or "off 2" or "off 4".
- when display B shows "on 3" it means that programme 2 is applicable on
day 3 of the week (Wednesday). On Day 3 (Wednesday) the stove will now
start at the time programmed at "UT 08" and switch off at the time pro-
grammed at "UT09"
- when display B shows "off 3" it means that programme 2 is not applicable.
On day 3 (Wednesday) programme 2 has no effect on the stove.
ing P2. Pressing P2 when display B shows "on 3' will change display B into "off
3". Pressing P2 again will show "on 3" again.
that requires a change. The change from On to Off can than be done using
P2.
Day 1 Day 2
Monday Tuesday
off 1 on 2
Diameter 6 mm.
Maximum length 30 mm.
Wood pellets according to DIN+ standard or according to Ö-norm.
Well pressed, no residuals of glue, resin or additive.
Surface is shining and smooth
Uniform in length and low dust content
Residual moisture: < 10%
Day 3 Day 4 Day 5
Wednesday Thursday Friday
off 3 off 4 on 5
Day 6 Day 7
Saturday Sunday
on 6 off 7