Zibro Tosca Manuel D'utilisation page 103

Picture F1: Cleaning the
window.
Picture F2
Picture F3
Picture F4
Picture F5
F.3.1 cleaning the outer- and inner surface of the stove
Clean the surface of the stove with (hot) water and soap. Do not use abrasive or
solvent based cleaning products as this might result in damage to the surface fin-
ish.
F.3.2 cleaning the window pane
Clean the glass regularly. The glass is heat resistant but can crack due to fast tem-
perature changes. Use normal glass cleaning spray and cleaning tissue. (Revert to
pict. F1).
Only clean the window pane glass when the stove has cooled down
completely!
F.3.3 cleaning the fire box
The fire box must be cleaned at least once every 2 weeks
1. R emove the burning pot from its seat by lifting it up and taking it out. See pict.
F2.
2. Take out the ash draw. See pict. F3.
3. Clean the area underneath the burning pot with a vacuum cleaner. See pict.
F4.
4. L ift the firebox back side wall at the back of the firebox, pull it towards you and
take it out. Clean the firebox wall using a soft brush and a vacuum cleaner, after
which it can be cleaned more intensively using soapy water. See pict. F5/F6.
5. Clean the area behind the removed firebox left hand side wall using a soft
brush and a vacuum cleaner. See pict. F7.
Only clean the fire box when the stove has cooled down completely!
Make sure the power supply to the stove is unplugged completely.
6. Replace the firebox left hand side wall.
7. Replace the ash draw
8. Replace the burning pot.
F.3.4 cleaning the burning pot
The burning pot needs cleaning at least before each start up and once every two
days of consecutive burning.
Only clean the burning pot when the stove has cooled down completely!
1. Take out the burning pot by lifting it up from its seat.
4 1
103