Zibro Tosca Manuel D'utilisation page 96

and will continue the heating mode.
D.9 FLUe gas TeMPeRaTURe
Pressing P1 during normal operating mode will show indication of flue gas tem-
perature in display B for 3 seconds.
D.10 FiLLing The PeLLeT hOPPeR WiTh PeLLeTs
Filling the pellet hopper during operation of the unit must be avoided.
Pellets must be loaded into the pellet hopper (item 28 on important component
drawing) carefully. Make sure that in all cases the pellet hopper can always be
completely closed with the pellet hopper cover (item 13 on important components
drawing). Do not fill the fuel hopper with any residuals from the burning pot.
For more information about the advised pellets: see chapter D12.
D.11 TiMeR anD cLOcK
The stove is provided with a clock and a weektimer. The stove can be programmed
via 2 individual programs.
The parameters are:
• UT01 to set the day
• UT02 to set the hour
• UT03 to set the minute
• U T04 to set technical parameters (reserved for Zibro authorized technicians
• UT05 to set starting time for Program 1
• UT06 to set switching off time for Program 1
• UT07 to choose the week days using Program 1
• UT08 to set starting time for Program 2
• UT09 to set switching off time for Program 2
• UT010 to choose the week days using Program 2
D.11.1. setting the clock
Make sure the stove is in normal operating mode or is in "off" mode.
To set the day of the week:
1. press P3 2 times, display A will show "UT 01".
2. p ress P1 or P2 until display B shows the actual, current day of the week (see
3. confirm day of the week by pressing P4
4
96
Never touch any rotating parts inside the pellet hopper. To avoid any risk
to touch the rotating parts inside the pellet hopper it is best to always
switch off the stove completely by disconnecting the electrical plug from
mains.
Should re-filling during operation be required than make sure that the
pellets and/or the pellet bag will not come in contact with any hot surface
of the stove as this might lead to dangerous situations. Make sure to never
touch any rotating parts inside the pellet hopper.
only)
table 1)