Ultrasound Operation With Heating - Bandelin SONOREX DIGITEC Mode D'emploi

Cleaning time
Cleaning time must be kept as short as possible. Depending on the degree of soiling
and the cleaning liquid used (see the data on its label), the cleaning time varies between
1 and 15 minutes.

2.4.3 Ultrasound operation with heating

• Switch on the unit (press key On/Off) – green LED on the temperature scale and yellow
LED of the last selected time on the time scale lights up.
• Select target temperature – increase value gradually by pressing the Temperature key
target temperature
actual temperature
• When target temperature is higher than actual temperature, heating phase starts
immediately. As long as heating is switched on, ultrasound is being switched on for
3 sec per min. See under 2.5 temperature – avoid retardation of boiling.
• As soon as the target temperature is reached, heating switches off = lighting LED.
• Switch off heating:
Press Temperature key longer than 2 sec – green LED lights up.
Start without modifi cation of time:
• By pressing the key Start/Stop, ultrasound is being switched on.
This is indicated on the time scale by means of a running light of the balance time.
• By pressing the key Time, ultrasound output can be interrupted (pause).
It is possible to modify the target temperature by pressing the key Temperature.
• By pressing the key Time again, ultrasound output will be continued (balance time).
Start with modifi cation of time:
• Select time - by pressing the key Time the duration will be gradually increased.
Numeral (1 ... 30)
Continuous operation (∞) =
• By pressing the key Start/Stop, ultrasound is being switched on
This is indicated on the time scale by means of a running light of the balance time.
• By pressing the key Time, ultrasound output can be interrupted (pause).
It is possible to modify the target temperature by pressing the key Temperature.
• By pressing again the key Time, ultrasound output will be continued (balance time).
• After run off of selected time, the unit stops and LED of previously selected time lights
up.
• Switch off the unit by pressing the key On/Off.
The last selected time will be stored.
Attention! Observe leads for operation and special functions – chapter 2.5
= lighting, yellow LED
= blinking, yellow LED
= lighting, yellow LED
lighting, green LED
23