Publicité
Les langues disponibles
Les langues disponibles
To install the blade
1. Make sure the tool is unplugged from the power source.
2. Rotate the lower guard upwards as far as possible.
3. Mount the blade carefully onto the spindle, being sure that the directional arrow on the blade surface matches the arrow on the upper blade guard.
4. Install the outer flange and small flat washer.
5. Rotate the lower guard to blade changing position. (See FIG 13)
6. Install the blade changing bolt and turn it finger tight in a counterclockwise direction.
7. Depress and hold down the spindle lock while tightening the blade locking bolt securely with the provided wrench in a counterclockwise direction.
8. Release the lower guard to its original position.
9. Be sure the spindle lock has released and blade rotates freely before plugging in the tool and making a cut.
CLEANING
Avoid using solvents when cleaning plastic parts. Most plastics are susceptible to damage from various types of commercial solvents and may be damaged
by their use. use clean cloths to remove dirt, dust, oil, grease, etc.
WArning:
Do not at any time let brake fluids, gasoline, petroleum-based products, penetrating oils, etc., come in
contact with plastic parts. Chemicals can damage, weaken ordestroy plastic which may result in serious personal injury.
Electric tools used on fiberglass material, wallboard, spackling compounds, or plaster are subject to accelerated wear and possible premature failure
because the fiberglass chips and grindings are highly abrasive to bearings, brushes, commutators, etc. Consequently, we do not recommended using this
tool for extended work on these types of materials. However, if you do work with any of these materials, it is extremely important to clean the tool using
compressed air.
LUBRICATION
This table saw are permanently lubricated at the factory and require no additional lubrication.
TWO-YEAr WArrAnTY
This product is warranted free from defects in material and workmanship for 2 years after date of purchase. This limited warranty does not cover normal
wear and tear or damage from neglect or accident. The original purchaser is covered by this warranty and it is not transferable. Please return the tool
to store location of purchase along with your receipt, and you will receive a new drill or a refund. THIS PRODUCT IS NOT WARRANTED IF USED FOR
INDUSTRIAL OR COMMERCIAL PURPOSES.
TOLL-FrEE HELP LinE
For questions about this or any other GENESIS Product, please call Toll-Free:
www.richpowerinc.com
Or visit our website:
888-552-8665
.
15
Publicité
