Cleaning And Care - SOLIS CHAMBER VAC PRO Mode D'emploi

C LE A NIN G A N D C A R E
s
Please proceed as follows to clean your vacuum sealer:
1. Switch the appliance off with the ON/OFF button and always disconnect the
power plug from the power socket.
2. Do not dip the appliance, the cord or the plug in water or any other liquid and
do not hold it under running water.
3. Do not use any aggressive detergents or solvents or any scratching materials to
clean the appliance, this might damage the surfaces.
GB
4. Open the lid and fold the bag fixation clamp up. You can yank the sealing bar
out of its holder. Beneath it, you can find a yellow filter lid. You can pull it up
and away as well.
5. On the underside of the filter lid, there is a fine air filter which cleans the air
before it is sucked in. You can clean this air filter with a slightly moist towel or
a soft brush.
6. Clean the vacuum chamber, the appliance lid on the inside and the outside and
the outside of the appliance with a mild detergent and a soft, moist towel.
7. After that, push the dry filter lid back onto the air intake.
130
8. Push the sealing bar back into the holder so that it locks into place. Also, fold
the bag fixation clamp back down.
Note: The rubber contact strip above the sealing bar can be easily removed from
●
the holder for easy manual cleaning in warm dishwater. Let the rubber contact
strip air dry completely before correctly reinserting it.
09. Let the appliance air dry completely before storing it or using it again.
10. The appliance does not need to be oiled.
AP PLI A NC E STOR AGE
s
Store the appliance in a flat, dry place, outside of the reach of children and best
keep it in the original packaging.
Do not place anything on the appliance so that no pressure is applied to the seals.
Seals and the sealing bar are consumable materials and are not covered by war-
ranty.
GB
131