EINHELL Bavaria BPS 800 E Instructions De Service page 7

Anleitung BPS 800 E SPK1
screws. The teeth of the saw blade must face in
cutting direction. Make sure that the saw blade sits
properly in the guide slot of the ram and roller.
Adjusting the base (Figure 3)
For mitre and bevel cuts you can swivel the base by
up to 45° in either direction after undoing the two
screws (a) on the bottom. The angles 15°, 30° and
45° are marked but you can adjust the saw to any
angle between these markings as required.
To adjust the cutting angle, undo the two screws (a)
until you can just about move the blade. Adjust to the
required angle and re-tighten the two screws.
ON/OFF switch for laser/LED (Figure 4)
You can switch the laser and the LED light ON and
OFF with the switch 12.
The laser beam marks the cutting path on the work-
piece.
Pos. 0 Laser and LED off
Pos. 1 Laser on
Pos. 2 LED on
Pos. 3 Laser and LED on
5. TECHNICAL DATA
Nominal voltage: 230 V ~ 50 Hz
Power consumption:
Cutting rate: 0-3000 strokes/min.
Stroke height:
Cutting depth in wood:
Cutting depth in plastic:
Cutting depth in iron:
Mitre cuts: up to 45° (left and right)
Sound pressure level LPA:
Sound power level LWA:
Vibration a w ≥ 2,8 m/s
Double isolation
Weight
Laser class
Laser wave length 635-680 nm
Laser output
23.05.2006 11:01 Uhr Seite 7
6. Cleaning, maintenance and ordering
of spare parts
Always pull out the mains power plug before starting
any cleaning work.
Cleaning
Keep all safety devices, air vents and the motor
housing free of dirt and dust as far as possible.
Wipe the equipment with a clean cloth or blow it
with compressed air at low pressure.
We recommend that you clean the device
immediately each time you have finished using it.
Clean the equipment regularly with a moist cloth
and some soft soap. Do not use cleaning agents
or solvents; these could attack the plastic parts of
the equipment. Ensure that no water can seep
into the device.
Carbon brushes
In case of excessive sparking, have the carbon
brushes checked only by a qualified electrician.
Important! The carbon brushes should not be rep
laced by anyone but a qualified electrician.
Maintenance
There are no parts inside the equipment which
require additional maintenance.
800 W
20 mm
7. Ordering replacement parts
80 mm
25 mm
Please quote the following data when ordering repla-
cement parts:
10 mm
Type of machine
Article number of the machine
87 dB(A)
Identification number of the machine
Replacement part number of the part required
98 dB(A)
For our latest prices and information please go to
2
www.isc-gmbh.info
II /
2,4 Kg
2
≤ 1 mW
GB
7