Alarm Messages - Olsberg Tellus Aqua plus Mode D'emploi

The delivery contents of the unit include a remote
control.
This is an infrared remote control. You must therefore
point it at the receiver unit on the back of the unit to
operate it.
If the reception is not optimum, then please change
the position of the receiver from horizontal to vertical.
Make sure that the sensor points to the centre of the
room.
The following unit settings can be made with the re-
mote control:
•
Start ignition process
•
Switch off
•
Change heating power setting P
The change to the heating power will be indicated by
means of an acoustic signal. If level A is selected (=
Automatic), the signal sounds 3x.
The control lamp of the remote control flashes when
the buttons are pressed.
a
Ignition
Press Key 3.
Switch off
Press Key 4.
Change heating power
Press one or both of the buttons that are marked
with a flame.
Increase
Decrease

14. Alarm messages

Any operational faults are shown in the display by
means of alarm messages. In addition, an acoustic
signal sounds.
The pellet feed is interrupted, the exhaust gas venti-
lator runs until the oven has cooled down.
14.1. Resetting the alarm message
After the cause of the fault has been eliminated, the
alarm message in the display can be reset as follows:
•
Wait until the unit has cooled down completely.
•
Press the OFF button for 5 seconds to reset the
alarm message.
•
The message FINAL CLEANING appears
•
If necessary, remove any combustion residue
from the combustion chamber.
•
Reset the FINAL CLEANING message with
OFF.
•
Restart the unit.
If the error message appears again immediately, then
contact your dealer to eliminate the cause.
14.2. Alarm SMOKE TEMP.
This occurs if the flue gas temperature is not ade-
quate for safe operation of the unit.
Possible causes:
•
No more pellets in the storage container
•
The quality of the pellets is inadequate (e.g.
damp)
37
1
2 .